Valve Cleaning without Dismantling

Valve Cleaning with TUNAP Valve Clean Technology

Clean Valves without Dismantling

Valve Clean Technology enables quick and easy valve cleaning without removing the cylinder head. With the microflex^® 933 valve cleaning granulate, contaminated or coked valves are cleaned or blasted with compressed air without leaving any residues or damage. At the same time, detached impurities and used granules are sucked off. Possible residues and coking are then dissolved without residue using the microflex^® 936 neutralization solution.

Advantages of TUNAP valve cleaning

Quick and easy valve cleaning without removing the cylinder head
Material-friendly cleaning, surfaces are not attacked
70% time savings through cleaning without dismantling
Around 2,000 EUR cost savings for end customers
Health-friendly valve clean technology, without allergy triggers
Optimal cleaning result

Clean Valves without Dismantling in the Video

Valve Cleaning in a Direct Comparison

Contaminated Valves: Problems, Causes and Solutions

Problems

Loss of performance, increased fuel consumption and rough idling are symptoms of valve deposits and contamination. The cause is a combination of exhaust gas recirculation and crankcase ventilation and lack of the physical flushing effect of fuel in direct injection systems.

Causes

Unfavourable driving habits such as frequent short trips and stop and go traffic together with increasing bio ingredients in fuel worsen matters.

Solution

Quick cleaning instead of hours of disassembly work: the new TUNAP Valve Clean System efficiently removes valve deposits and saves motorists four figure sums.

Notes on dirty or coked valves

Coking, contamination and deposits on valves and inlet ducts can be noticeable by the following signs:

Misfire
Increased fuel consumption
Loss of engine power
Rough idle

Process of TUNAP valve cleaning

The intake manifold and attachments are dismantled
Valves are irradiated and cleaned with the cleaning granulate
Used granulate and impurities are sucked off
Residues and coking are dissolved with the neutralization solution

Optimal cleaning result

The impact of the granulate releases the surface tension of the deposits on the inlet valves and the surrounding ducts. The coking and dirt are gently loosened without damaging the valves or even damaging the engine.

The TUNAP valve cleaning not only leads to an optimal cleaning result, it is also health-friendly and does not contain any allergy-causing substances.